There are three Icon "palettes" you can bring up in the dock along the left
hand side of the NXT Programming tool: "Common Palette", "Complete palette",
and "Custom palette".  They are selected by the three tabs along the bottom.
The default is the left tab: "Common Palette".  Select the center tab -
"Complete palette".  Under the second icon (Yellow-green square with arrow
coming out the top) the first icon pull-out will be labeled "Motor".  This
is the tool to control a single motor (as opposed to the "Move" icon under
the common palette, which controls multiple motors).  Hope this helps..

- glenn



-----Original Message-----
From: First Lego League in Virginia and DC
[mailto:[log in to unmask]] On Behalf Of Robert Haskins
Sent: Tuesday, November 03, 2009 5:14 PM
To: [log in to unmask]
Subject: [VADCFLL-L] Programming problem

While on the subject of programming. My team, and subsequently I, have
not been able to figure out how to set the power and direction on two
motors independently. I know how to do this with the RCX software, but
I cannot figure this out using the NXT.

Any pointers?

-- 
Haskins Family Farm
Middletown, VA
http://www.localharvest.org/farms/M20435

-- To UNSUBSCRIBE or CHANGE your settings, please visit
https://listserv.jmu.edu/archives/vadcfll-l.html and select "Join or leave
the list".

-- VADCFLL administrative announcements are sent via VADCFLL-ADMIN-L. Visit
https://listserv.jmu.edu/archives/vadcfll-admin-l.html to subscribe.

-- To UNSUBSCRIBE or CHANGE your settings, please visit https://listserv.jmu.edu/archives/vadcfll-l.html and select "Join or leave the list".

-- VADCFLL administrative announcements are sent via VADCFLL-ADMIN-L. Visit https://listserv.jmu.edu/archives/vadcfll-admin-l.html to subscribe.