> From the Common palette, drop a Move block onto a sequence beam.  Drop a 
> second Move block below it but not on the sequence beam.  Starting at the 
> second block depress the shift key and right mouse button and a wire spool 
> image will appear.  By dragging your mouse, connect the spool to the upper 
> sequence beam immediately before the Move block you inserted.  Set one 
> Move block to B and the other to C and likewise one Move block to Forward 
> and the other to Reverse.
>
> This is an example of parallel processing.  Also, you can use Motor blocks 
> from the Complete palette to accomplish the same objective but with added 
> functionality like ramping up/down the motor speed.
>
> Charlie Aldridge
>
> ----- Original Message ----- 
> From: "Robert Haskins" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Tuesday, November 03, 2009 5:14 PM
> Subject: [VADCFLL-L] Programming problem
>
>
>> While on the subject of programming. My team, and subsequently I, have
>> not been able to figure out how to set the power and direction on two
>> motors independently. I know how to do this with the RCX software, but
>> I cannot figure this out using the NXT.
>>
>> Any pointers?
>>
>> -- 
>> Haskins Family Farm
>> Middletown, VA
>> http://www.localharvest.org/farms/M20435
>>
>> -- To UNSUBSCRIBE or CHANGE your settings, please visit 
>> https://listserv.jmu.edu/archives/vadcfll-l.html and select "Join or 
>> leave the list".
>>
>> -- VADCFLL administrative announcements are sent via VADCFLL-ADMIN-L. 
>> Visit https://listserv.jmu.edu/archives/vadcfll-admin-l.html to 
>> subscribe.
> 

-- To UNSUBSCRIBE or CHANGE your settings, please visit https://listserv.jmu.edu/archives/vadcfll-l.html and select "Join or leave the list".

-- VADCFLL administrative announcements are sent via VADCFLL-ADMIN-L. Visit https://listserv.jmu.edu/archives/vadcfll-admin-l.html to subscribe.