> From the Common palette, drop a Move block onto a sequence beam. Drop a > second Move block below it but not on the sequence beam. Starting at the > second block depress the shift key and right mouse button and a wire spool > image will appear. By dragging your mouse, connect the spool to the upper > sequence beam immediately before the Move block you inserted. Set one > Move block to B and the other to C and likewise one Move block to Forward > and the other to Reverse. > > This is an example of parallel processing. Also, you can use Motor blocks > from the Complete palette to accomplish the same objective but with added > functionality like ramping up/down the motor speed. > > Charlie Aldridge > > ----- Original Message ----- > From: "Robert Haskins" <[log in to unmask]> > To: <[log in to unmask]> > Sent: Tuesday, November 03, 2009 5:14 PM > Subject: [VADCFLL-L] Programming problem > > >> While on the subject of programming. My team, and subsequently I, have >> not been able to figure out how to set the power and direction on two >> motors independently. I know how to do this with the RCX software, but >> I cannot figure this out using the NXT. >> >> Any pointers? >> >> -- >> Haskins Family Farm >> Middletown, VA >> http://www.localharvest.org/farms/M20435 >> >> -- To UNSUBSCRIBE or CHANGE your settings, please visit >> https://listserv.jmu.edu/archives/vadcfll-l.html and select "Join or >> leave the list". >> >> -- VADCFLL administrative announcements are sent via VADCFLL-ADMIN-L. >> Visit https://listserv.jmu.edu/archives/vadcfll-admin-l.html to >> subscribe. > -- To UNSUBSCRIBE or CHANGE your settings, please visit https://listserv.jmu.edu/archives/vadcfll-l.html and select "Join or leave the list". -- VADCFLL administrative announcements are sent via VADCFLL-ADMIN-L. Visit https://listserv.jmu.edu/archives/vadcfll-admin-l.html to subscribe.