From our experience, the broken pipe should sit in a space that is about 25% larger than it is. It should also easily be lifted straight up out if this original starting position. Take a look at your green sides to make sure the wedges are properly placed underneath and properly mounted on the mat. Good luck, Vince Shier On Tue, Oct 17, 2017 at 8:10 PM, Frank Levine <[log in to unmask]> wrote: > Hello, > Is the broken pipe in M01 supposed to require a little force to remove > it from the table? When our robot attempts to lift the pipe, the pipe is > getting hung up on the model. This is driving my team toward a > gearing-down solution, which will certainly work, but my question is... > should the model behave like that? Are we experiencing what everyone else > is experiencing? It seems that this behavior is very dependent on the > placement of the two green sides, and that placement causes a very distinct > change in the solution required to remove the pipe. I understand that > model variability is part of the game, but I'm curious to hear what folks > have been experiencing. > > Thanks, > Frank Levine > > ------------------------------ > To UNSUBSCRIBE or CHANGE your settings, please visit > https://listserv.jmu.edu/archives/vadcfll-l.html and select "Join or > leave the list". > VADCFLL administrative announcements are sent via VADCFLL-ANNOUNCEMENTS-L. > Visit https://listserv.jmu.edu/archives/vadcfll-announcements-l.html to > subscribe. -- To UNSUBSCRIBE or CHANGE your settings, please visit https://listserv.jmu.edu/archives/vadcfll-l.html and select "Join or leave the list". -- VADCFLL administrative announcements are sent via VADCFLL-ANNOUNCEMENTS-L. Visit https://listserv.jmu.edu/archives/vadcfll-ANNOUNCEMENTS-l.html to subscribe.