Thu, 6 Jun 2019 12:48:44 -0400
|
I haven't used the robots for a while and when I get them out, and I can
write programs and load the programs onto 12 robots. 11 of the robots work
fine, but one won't recognize the light or sound sensor. It recognizes a
touch sensor. I have verified the sensors works by swapping sensors and
cables with other robots (multiple times, with another teacher who is an
electrical engineer watching). If I try going to "View" the sensors (on the
correct ports), I get a value of "0". I have reloaded the firmware.
Any ideas?
Donald Williams P.E.
Phoebus High School
100 Ireland Street
Hampton, VA 23663
757-727-1031
--
----
CONFIDENTIALITY NOTICE: This email message, including any
attachments, is for the sole use of the
intended recipient(s) and may
contain information that is legally privileged, confidential and/or exempt
from
disclosure under applicable law. If you are not an intended
recipient, you may not review, use, copy, disclose
or distribute this
message or any of the information contained in this message to anyone. If
you are not the intended
recipient, please contact the sender by reply
email and destroy all copies of this message and any
attachments. Hampton
City Schools may monitor e-mail messages to and from the Hampton City
Schools
network. Unintended transmission shall not constitute waiver of
any privilege or confidentiality protected under
federal statutes, the
Virginia Freedom of Information Act or any applicable laws.
-- To UNSUBSCRIBE or CHANGE your settings, please visit https://listserv.jmu.edu/archives/vadcfll-l.html and select "Join or leave the list".
-- VADCFLL administrative announcements are sent via VADCFLL-ANNOUNCEMENTS-L. Visit https://listserv.jmu.edu/archives/vadcfll-ANNOUNCEMENTS-l.html to subscribe.
|
|
|